Management of soil cover and tillage regimes in upland rice-sweet corn systems for better system performance, energy use and carbon footprints.

This study investigates the effects of tillage and mulching regimes on rice-sweet corn systems in the lower Gangetic plains, focusing on region-specific and crop-specific impacts on soil-crop-environmental parameters. The experiment consisted of three levels of tillage: conventional (CT), minimum (MT), and zero (ZT), and four levels of mulching: live, leaf litter, paddy straw, and no mulching. The results show that ZT tillage resulted in higher bulk density (BD) compared to other treatments, despite an increase in soil organic carbon (SOC). Live and leaf litter mulching led to slight reductions in BD in the upper soil layers. CT resulted in net depletion of SOC whereas ZT registered a positive sequestration rate of 1.19 Mg ha-1 yr-1. Live and leaf litter mulching increased SOC sequestration by 42.6% and 38.8% compared to paddy straw mulching, respectively. Initially, ZT resulted in a 10.3% reduction in system productivity compared to CT, while MT yields were comparable to CT. However, mulching regimes consistently improved production by 16.4%-25.2% as compared to no mulch. ZT and MT were found to be more affordable than CT, with cost savings of 18.2% and 6.8%, respectively. ZT had the highest B: C ratio, indicating better economic efficiency. Among the mulching treatments, live mulching was the most economical. Both ZT and MT saved input energy by approximately 22.9% and 13.5%, respectively compared to CT. Live mulching resulted in the highest net energy and energy output. Compared to CT, ZT reduced carbon footprint (CF) by 41.5 and 22.2% in rice and sweet corn, respectively. MT scored midway between ZT and CT in all parameters. CT exhibited several limitations, including high input energy requirements, high cost of cultivation, poor economic efficiency, negative environmental impacts, and loss of SOC. ZT initially experienced yield reduction and lower net returns in the early years. Therefore, MT was identified as the best alternative in the initial years before transitioning completely to ZT, as it provided comparable yields to CT with better overall benefits. Among the soil cover regimes, live mulching was found to be the most favorable option across all dimensions.

Potentially toxic metals contamination, health risk, and source apportionment in the agricultural soils around industrial areas, Firozabad, Uttar Pradesh, India: a multivariate statistical approach.

Potentially toxic metals (PTMs) contamination in the soil poses a serious danger to people's health by direct or indirect exposure, and generally it occurs by consuming food grown in these soils. The present study assessed the pollution levels and risk to human health upon sustained exposure to PTM concentrations in the area's centuries-old glass industry clusters of the city of Firozabad, Uttar Pradesh, India. Soil sampling (0-15 cm) was done in farmers' fields within a 1 km radius of six industrial clusters. Various environmental (geo-accumulation index, contamination factor, pollution load index, enrichment factor, and ecological risk index) and health risk indices (hazard quotient, carcinogenic risk) were computed to assess the extent of damage caused to the environment and the threat to human health. Results show that the mean concentrations of Cu (33 mg kg-1), Zn (82.5 mg kg-1), and Cr (15.3 mg kg-1) were at safe levels, whereas the levels of Pb, Ni, and Cd exceeded their respective threshold limits. A majority of samples (88%) showed considerable ecological risk due to the co-contamination of these six PTMs. Health risk assessment indicated tolerable cancer and non-cancer risk in both adults and children for all PTMs, except Ni, where adults were exposed to potential threat of cancer. Pearson's correlation study revealed a significant positive correlation between all six metal pairs and conducting principal component analysis (PCA) confirmed the common source of metal pollution. The PC score ranked different sites from highest to lowest according to PTM loads that help to establish the location of the source. Hierarchical cluster analysis grouped different sites into the same cluster based on similarity in PTMs load, i.e., low, medium, and high.

Soil erosion control from trash residues at varying land slopes under simulated rainfall conditions.

Trash mulches are remarkably effective in preventing soil erosion, reducing runoff-sediment transport-erosion, and increasing infiltration. The study was carried out to observe the sediment outflow from sugar cane leaf (trash) mulch treatments at selected land slopes under simulated rainfall conditions using a rainfall simulator of size 10 m × 1.2 m × 0.5 m with the locally available soil material collected from Pantnagar. In the present study, trash mulches with different quantities were selected to observe the effect of mulching on soil loss reduction. The number of mulches was taken as 6, 8 and 10 t/ha, three rainfall intensities viz. 11, 13 and 14.65 cm/h at 0, 2 and 4% land slopes were selected. The rainfall duration was fixed (10 minutes) for every mulch treatment. The total runoff volume varied with mulch rates for constant rainfall input and land slope. The average sediment concentration (SC) and sediment outflow rate (SOR) increased with the increasing land slope. However, SC and outflow decreased with the increasing mulch rate for a fixed land slope and rainfall intensity. The SOR for no mulch-treated land was higher than trash mulch-treated lands. Mathematical relationships were developed for relating SOR, SC, land slope, and rainfall intensity for a particular mulch treatment. It was observed that SOR and average SC values correlated with rainfall intensity and land slope for each mulch treatment. The developed models' correlation coefficients were more than 90%.